3D Printer 6*20MM 12V/24V 50W Heater Cartridge With 100CM/200CM cable For 3D Printer V6 PT100 HOT End Volcano MK8 MK9
Voltage: 12 V
Power: 50 W
Heating head size: 6mm Diameter * 20mm Length
Material heating head: Stainless Steel
Length of the line: 100cm / 200cm
Color: as shown in the picture
Heating temperature: up to 350 ℃
The improvement compared to the normal red heater:
1. from ordinary original 0.3-line high-line of this temperature to 0.5-line thick white high-temperature line, can withstand the highest temperature, and looks more beautiful.
2. from original 40W of power to 50W, therefore, the maximum temperature increases from 300-31 ℃ to 340-350 ℃ or so.
3. the new heating version used in all imported skills, the use of 304 stainless steel, with the internal use of 2080 nickel chrome wire to achieve maximum life span.
4. Support the customization of different specifications, length, heater resistance.
5. Can be used with the new HT-NTC100K temperature thermistor (Temperature measurement can be up to 350 ℃ ).
1. The effective heating part of the heater must keep dry.
2. The electrical connector of the single-ended heater should be placed out of the insulation layer and heating room, and the working voltage shall not exceed its rated value of 10%. The shell should be effectively grounded.
3. Electric components working environment, the temperature should not be greater than 95 degrees, no explosive or corrosive gases.
4. Electric components should be stored in a dry place.
1x Cartridge Heater.